CombiMaster 230V Series
– User and Installation Manual
19
Field
Meaning
Value
Event x source
Select an event that triggers an action, for example Battery pre low.
See
Event source
list
Event x target
Select the device that should take action, for example the generator
System dependent
Event x command Select the parameter that must be changed on the target device, for
example Activate.
See command list of the selected
device
Event x data
Data, for example On, is linked to the command.
Off, On, Copy, Copy Invert,
Toggle
Table 1: MasterBus event parameters
The CombiMaster can be configured as an
event source
. An event source can be used to initiate an
event command
and an
event action
by another device that is connected to the MasterBus.
Event source
Description
Inverting
The CombiMaster is in Inverter mode
Charging
The CombiMaster is in Charger mode
Supporting
The CombiMaster is in Supporting mode
Overload
The loads exceed the nominal inverter power
DC low voltage
The main battery voltage has dropped below the Low bat value
Alarm
A CombiMaster alarm has been triggered
AC IN present
AC input is present
Bulk
Charge phase Bulk
Absorption
Charge phase Absorption
Float
Charge phase Float
AC IN Limit A
AC input is set to 6A
AC IN Limit B
AC input is set to 10A
AC IN Limit C
AC input is set to 16A
Table 2: CombiMaster 230V Series MasterBus Event sources
When the CombiMaster is configured as an
event target
by another device, this device can initiate an
event command
and an
event action
to be performed by the CombiMaster.
Event command
Description
Inverter
Change the CombiMaster inverter state
Charger
Change the CombiMaster charger state
AC limit A
Fuse setting of the AC input is set to 6A (adjustable)
AC limit B
Fuse setting of the AC input is set to 10A (adjustable)
AC limit C
Fuse setting of the AC input is set to 16A (adjustable)
Bulk
Changes to charge phase Bulk
Absorption
Changes to charge phase Absorption
Float
Changes to charge phase Float
Table 3: CombiMaster 230V Series MasterBus Event commands
5.3
CZone configuration
The CZone
®
network is an NMEA 2000-compliant CAN-based system. When the CombiMaster is connected, open the CZone
Configuration Tool on a Windows laptop or notebook connected to the CZone network. Either do the configuration while
connected to the network or use a prepared configuration file (.zcf). For detailed information on the configuration also see
section 5.2.4.
For more information, please refer to the CZone
®
Configuration Tool Instruction manual.