14
INSTALLING A BLADE
– cont’d
2. Push upward on the blade locking
lever (2) (Fig. 3).
3. Insert the appropriate blade (3) into
the blade slot (4) as far as it will go.
NOTE:
Make sure the rear edge of the
blade is nested in the blade guide roller
(5).
4. Release the blade-locking lever.
NOTE:
The blade will automatically be
locked into the blade holder. Pull outward
on the blade to ensure it is properly locked
into the blade holder.
REMOVING A BLADE
To remove a blade, simply push upward
on the blade locking lever and remove the
blade from the blade holder.
HEX KEY STORAGE
The
1/8” (3 mm) hex key (1) for adjusting
the bevel cutting angle is stored in the
lower part of the battery cavity (2) (Fig. 4).
SETTING THE BEVEL CUTTING ANGLE
Bevel cutting angles may be adjusted from
0° to 45° either left or right. To adjust the
bevel angle:
1. Loosen both base pivot screws (1)
until the base (2) can be rotated
(Fig. 5).
NOTE:
Use 1/8" (3 mm) hex key supplied.
ASSEMBLY AND OPERATING
Fig. 3
Fig. 5
Fig. 4
Summary of Contents for 54-8110-2
Page 12: ...12 CONTENTS...
Page 23: ...23 EXPLODED VIEW...