Mastercook KG-1514ZSB DYN, Instruction Manual

Page: 29 / 36

EN
28
Adjusting the taps:
open the gas flow with the knob and light the bur - –
ner to be adjusted,
set the knob in simmering flame position
– , and
then, maintaining that position, remove the knob
from the tap pin and watch the burner’s flame
turn the adjustment screw “A” (7.4.1) and watch –
the flame; set the flame to such a size that will pre -
vent it from being extinguished by a slight draught
or during the operation of quickly turning the knob
from the full to the simmering position of the flame
and back;
the adjustment is correct when the core of the fla - –
me is cone-shaped in green and blue colour and is
ca. 2 – 4 mm tall
if there are perceptible changes of gas pressure in –
the gas supply system (change in the size of fla -
me at full flow), the simmering flame should be set
when pressure in the system is low to prevent the
burner from extinguishing during normal use,
upon adjusting the taps, put the knob back in its –
position and turn off the flame.
The amount of gas used with taps set to minimal gas
flow corresponds to ca. 25 % of use when the taps
are set to full flame.
8.1 The cooker is equipped with the power cord with
a plug and must be connected to a mains socket
properly fitted with earth contact (fig. 8.1.1).
8.2 If the power cord is not fitted with a plug, the plug
must be connected to it. The cord must be fitted
with a plug with a proper grounding prong. Befo -
re connecting to a power supply, ensure that:
– the voltage indicated on the nameplate matches
the mains voltage at the site where the appliance
is connected
– the performance of the power supply at the place
of connection is sufficient to meet the maximum
power requirements of the appliance, as specified
on the nameplate.
The mains socket should be easily accessible •
to the user.
Make sure that the power cord does not come •
into contact with hot parts of the cooker.
9.1 Knobs
The gas flow in particular burners is opened and clo -
sed with the use of knobs fitted on the gas taps. Be -
fore turning the burner on, make sure that the knob
you are about to turn corresponds to the burner which
is to be used. The burners and their corresponding
knobs are shown in fig. 9.1.1.
9.2 Setting the flame
The flame should not lick around from the bottom of
a pan. The size of flame depends on the position of
the knob (9.2.1, 9.2.2, 9.2.3).
0 – burner switched off (flow of gas shut off);
- large flame; - small flame (simmering)
2E-G20 20mbar 2E-G20 13mbar 3B/P-G30 30mbar
Small burner X072 084 050
Medium burner Z097 110 065
Large burner Y118 145 085
Oven burner P1 P9 P2
Oven
Arrangement of
burner nozzles
Table 1 Burner nozzle specification