NTP100 – Rev 1.0.1 Dec-04
4
© Masterclock
®
, Inc.
Model NTP100-GPS
1. Locate the antenna in a suitable area so that the top of the antenna module has a clear view of the sky. Do not move it
until after the NTP100-GPS has achieved satellite lock (explained below).
2. Connect the antenna coax to the gold SMA connector on the rear of the unit (labeled
Antenna
).
Continue at step 4
Model NTP100-TC
3. Connect the time code signal cable to BNC female connector on the rear of the unit (labeled
Time Code Input
), and then
to a valid UTC referenced time code signal source.
[Note: The NTP100-TC auto-detects and decodes the date encoded incoming time code signal as UTC referenced time and
treats the incoming time code signal as UTC referenced. Non-date encoded SMPTE or IRIG-B/B(1)
Continue at step 4
All NTP100 Models
4. Connect an RJ-45 10-baseT ethernet cable to the female RJ-45 connector on the rear of the unit (labeled
Ethernet
), and
then to a hub or switch on your ethernet network.
NTP100-GPS Rear View
NTP100-TC Rear View
