Generation II Entree Bath
–
All Models
ARCHITECTURAL SPECIFICATIONS & ROUGH-IN INFORMATION
07-06-15
Page 4 of 5
2071 14
th
Ave – Columbus, NE 68601
800-798-5867 FAX: 402-563-9102
www.mastercarebath.com
EXTENDED LENGTH MODELS
Exterior Dimensions
Width
All models below (Door Closed) ................................................... 36"
Width
All models below (Door Opened) ................................................. 34.25"
Length MB-59-AV (XL) —Alcove Placement ............................................. 65.5"
Length MB-68-AVH (XL) —Optional Head End Corner Placement .............. 68.5"
Length MB-68-AVF (XL) —Optional Foot End Corner Placement ............... 68.5"
Length MB-68-AV (XL) —Standard Wall Placement .................................. 71.5"
Height All models above (top of controls ................................................ 46.5"
Optional Recessed Access Door Available For Island and Peninsula Placement.
Interior Dimensions
Length-Straight .......................................................................................... 51”
Length-Diagonal ........................................................................................ 52”
Seat Depth ............................................................................................... 22” at Widest Point
Seat Area Width (w/ Door Closed) ............................................................. 25”
Seat Height................................................................................................ 21.5”
Specifications
Back Flow Prevention:
Double check valves for shower wand complies with CSA B64.7, UPC, Certified to
NSF/ANSI 372, ASSE 1035—“Laboratory Faucet Vacuum Breakers”. Fill: 1.5” a gap
above rim complies with National Plumbing Standards. (See plumbing standards
below.) Note: The factory provided backflow prevention is the most widely accepted.
Local codes may require changes. The local plumbing contractor is responsible for any
changes.
BathAire
(SM)
Outlets:
4 with 12 ports each for a total of 48 warm air massage outlets.
Door Seal:
Seal certified by Warnock Hersey to the ASME A112.19.15-2005, CSA B45.0-02
(R2008) and ANSI Z124.1.2 (2008) standards to ensure long lasting durability for
bathtubs with pressure sealed doors. Highly resistant to oils, detergents and all water
conditions.
Electrical:
Factory provided on board installed dead front GFCI: UL/CSA approved.
Installation Time:
1 hour (when water and electrical supplies meet the provided rough-ins).
Inspection and Adjustments: 1/2 hour
Motor Specs:
Door motor: 115 V, 4.2 Amp, 1/3 H.P.
BathAire
(SM)
Motor: 120 V., 11 Amp, 1.3 H.P. Variable speed with built-in 600 watt
heating element for maximum comfort and control.
Room Size:
6’ 5" wide x 10’ 1½” long minimum recommended. Can fit in smaller room--call
