Generation II Entree Bath
–
All Models
INSTALLATION MANUAL
06-23-17
Page 8 of 11
2071 14
th
Ave – Columbus, NE 68601
800-798-5867 FAX: 402-563-9102
www.mastercarebath.com
Casual Water Drain
Connection in the Door
Casual Water Drain
Connection to the
Drain Pipe
13.
Tighten the hose clamps on the rubber couplers.
14.
Anchor the tub to the wall in two places with the anchor kit provided in the Entree Gen II Starter Kit box.
Select
the two stud locations as far apart as possible along the rear wall flange of the tub. Center on each stud using
the finishing washer in the kit and hold it just below the
black trim seal to mark the anchor hole location. Drill
3/16” holes at the marked locations through the
flange only. Anchor tub to wall with the # 10 x 3” SS
flat head self tapping anchor screws. You will need a #
2 sq. drill bit for this. If it is a masonry wall, installer is
responsible to select appropriate anchors.
15.
Proceed to the Gen II Entree Bath Operation Manual.
16.
Go through a bath cycle and verify all functions work
correctly.
17.
Make sure that when the fill knob is in the hot position, hot water comes out of the valve.
Check the water
temperature and verify it is in the proper range. Rotate the knob to mid range and verify the temperature "tracks
the knob" and reduces accordingly.
Note: If the hoses are connected backwards, the mixing valve will not function correctly.
18.
Check the GFCI,
located under the head end raised panel, and make sure it trips and resets properly.
19.
Make sure the tub is grounded according to code.
20.
Make sure the Casual Water Drain (located in the back side of the tub) is properly connected.
Tub
Anchor
Screw
Finishing
Washer
Tub Wall
Flange
Black Trim
Seal
Wall
Stud