13
ARMADO
PASO 15
Adjuntar mango ( 27 )
usando arandelas (C) y los
tornillos (I) como se muestra .
STEP 14
Adjunte el termómetro (2g) con
la base del termómetro (2b) a la
tapa de la parrilla (1) utilizando la
tuerca de mariposa.
1
2g
2b
Nota: La tuerca de mariposa
está empacada con el
termómetro.
Sugerencia:
Asegure que las medidas
de temperatura y el logotipo
Masterbuilt estén alineados
correctamente antes de apre-
tar la tuerca de mariposa.
TUERCA DE MARIPOSA
27
1
I
C
C
6
SHOR
T SIDE
FRONT
ASSEMBLY
*Note that the front of the grill is actually the shortest width of the bottom storage shelf (12).
• BEFORE ASSEMBLY READ ALL INSTRUCTIONS CAREFULLY.
• ASSEMBLE UNIT ON A CLEAN, FLAT SURFACE.
• TOOL NEEDED: PHILLIPS HEAD SCREWDRIVER
• UNPACK ALL PARTS AND LAY OUT IN FRONT OF YOU. CHECK TO MAKE SURE ALL PARTS
ARE IDENTIFIED AND ACCOUNTED FOR.
STEP 2
Attach wheel (16) to leg (19, “B”)
using cotter clip (D) and axle pin
(G) as shown.
Snap hubcap (15) onto wheel.
Repeat step for remaining wheel
and wheel leg (19 “D”).
STEP 1
Begin assembly by positioning
bottom shelf (12) with the short
side of shelf facing you.
This will actually be the front of
the grill, making the long sides of
shelf the left and right sides.
STEP 3
Align notch on back of foot (17)
with the slot in leg (18,”A”) and
insert into leg.
Repeat for remaining leg (18, “C”)
and foot (17).
LABELS
A
– Front Right,
B
– Front Left,
C
– Back Right,
D
– Back Left
16
19
19
15
G
12
C
D
B
17
18
17
18
18
A
A
ALIGN
NOTCH
NOTE:
DO NOT FULLY
TIGHTEN
ANY
SCREWS
UNTIL ALL SCREWS ARE IN
PLACE AND THE GRILL IS
FULLY ASSEMBLED.
D
