Master MAS-F20white, User Manual

Page: 67 / 95

67
EN
Tighten the rear roller only enough to prevent slippage at the front roller. Turn both
the right and left bolt clockwise reasonably and inspect for proper tension. When an
adjustment is made to the belt tension, you must also make a tracking adjustment to
compensate for the change in belt tension
DO NOT OVERTIGHTEN -
Over tightening will cause belt damage and premature bearing
failure .
4.6 Belt Tracking Adjustment
This treadmill is designed to keep the belt reasonably centred while in use. It is
normal for some belts to drift near one side while the belt is running with no one on
it. After a few minutes of use, the belt should have a tendency to centre itself.If
during use, the belt continues to move toward one side, adjustments are necessary.
The procedures are as below:
▲
First set speed at lowest position.
▲
Second check the belt shifts to which side.
If the belt shifts to right, tighten the right bolt and loosen the left bolt by using 6mm
Hexagonal Wrench, until the belt is centered itself; if belt shifts to left,tighten the left
bolt and loosen the right bolt by using 6mm Hexagonal Wrench,until the belt is
centered. When adjusting the belt using the 6 mm Hexagonal Wrenches, it is
important to adjust the belt in half turn increments. Over adjusting the belt can cause
damage to the mat.
5. TROUBLE SHOOTING
This treadmill is designed in a way that in the event of an electrical fault, the machine
will turn off automatically to prevent any injuries to the user and any damage to the
machine (i.e. motor).When the treadmill behaves erratically, simply reset the
treadmill by turning the power switch off, waiting for 1 minute then turning the power