12
EN
DO NOT OVERTIGHTEN - Over tightening will cause belt damage and premature bearing failure
.
4.6 Belt Tracking Adjustment
This treadmill is designed to keep the belt reasonably center while in use. It is normal for some belts to
drift near one side while the belt is running with no one on it. After a few minutes of use, the belt should
have a tendency to center itself. If during use, the belt continues to move toward one side, adjustments are
necessary. The procedures are as below:
▲ First set speed at lowest position.
▲ Second check the belt shifts to which side.
If the belt shifts to right, tighten the right bolt and loosen the left bolt by using 6mm Hexagonal
Wrench, until the belt is centered itself; If belt shifts to left, tighten the left bolt and loosen the right bolt by
using 6mm Hexagonal Wrench, until the belt is centered. When adjusting the belt using the 6 mm
Hexagonal Wrenches, it is important to adjust the belt in half turn increments. Over adjusting the belt can
cause damage to the mat.
5. TROUBLE SHOOTING
This treadmill is designed in a way that in the event of an electrical fault, the machine will turn off
automatically to prevent any injuries to the user and to prevent damage to the machine (i.e. motor).
When the treadmill behaves erratically, simply reset the treadmill by turning the power switch off, waiting
for 1 minute then turning the power button back on.
If, after you have reset the treadmill, it is still not running correctly, please run the self-checking analyse
(please refer to
Self-Checking
) to distinguish what type of error problem the machine is encountering.
5.1 Alarm signals
.E01 No feedback from speed sensor
1.Check the distance from speed sensor to the magnetic of roller,and adjust it within 3mm.
2. change speed sensor
E02 Over voltage protection of motor
1.Make the machine self-checking again
2..Change controller
Before attempting any work on the treadmill, ensure that the power is off and the plug is removed
from the power point.
Do not use extension leads as it may lead to power decrease and failure.
