SWITCHING ON
To start the heater:
•
Set the commutator (1) in the “O” position.
•
Turn the disconnecting switch on the electric board on.
•
Set the room thermostat (2) at the maximum level and set the commutator (1) in the
position: the
burner will start and, after the combustion chamber has begun to heat, the fan will start too.
•
If the heater does not start after you have completed the operations above, you should check the
“FUNCTIONING PROBLEMS: CAUSES AND SOLUTIONS” paragraph.
•
If the heater is working normally:
1)
Set the room thermostat at the desired level.
2)
Move the adjustable fins of the air head (9) to reach the desired position.
TURNING OFF
WARNING!
You should never stop the heater by simply turning off the disconnecting switch on the electric
board. The electricity supply must only be disconnected when the fan has completely stopped.
Turn the commutator (1), in the “O” position. The burner will stop, while the fan might turn off and on a few times
until the combustion chamber has completely cooled down.
VENTILATION
When the commutator (1) gets turned to the
position, the heater will work in continuous fan mode.
MAINTENANCE
WARNING!
The following operations have to carried out by qualified personnel only
For a correct work of the machine, it is necessary to perform the following operations periodically, remembering to
disconnect the power line before beginning.
Before carrying out any maintenance operation, you should:
•
Stop the machine as indicated in the previous paragraph.
•
Turn the disconnecting switch on the off position on the electric board.
•
Wait until the heater has completely cooled down.
HEAT EXCHANGER AND COMBUSTION CHAMBER CLEANSING
For the heater to operate efficiently, the heat exchanger and the combustion chamber have to be cleaned after a
period of prolonged use or even more frequently if you notice too much soot forms: that might happen with un
incorrect chimney draught, with a very bad quality fuel, with an incorrectly set burner or when the heater gets
turned on and off too often. If the heater starts vibrating when it is in the on position, there is probably too much
deposited soot.
