Masport PG36-3 Gas Inbuilt
33
MAINTENANCE
GOLD-PLATED or
BRASS LOUVRES
The 24 carat gold-plated or brass finish on the
louvres and trim requires little maintenance,
and need only be cleaned with a damp cloth. DO
NOT use abrasive materials or chemical clean-
ers, as they may harm the finish and void the
warranty. Clean any fingerprints off be-
fore turning the unit on.
GOLD-PLATED or
BRASS TRIM
The 24 carat gold plated or brass finish on the
trim requires little maintenance, and need only
be cleaned with a damp cloth. DO NOT use
abrasive materials or chemical cleaners, as
they may harm the finish and void the warranty.
Clean any fingerprints off before turning
the unit on. If the top louvres start to
discolour, check the door gasket seal
and replace if necessary.
LOG REPLACEMENT
The unit should never be used with broken logs.
Turn off the gas valve and allow the unit to cool
before opening door and carefully remove the
logs. If for any reason a log should need
replacement, you must use the proper replace-
ment log. The position of these logs must be as
shown in the diagrams under Log Installation.
Note: Improper positioning of logs may
create carbon build-up and will
severely alter the unit's perform-
ance which is not covered under
warranty.
GLASS GASKET
If the glass gasket requires replacement use
5/8" flat glass gasket for the Bay Front (Part #
936-243) and a tadpole glass gasket for the
Flush Front (Part # 936-155).
DOOR GLASS
Your Masport stove is supplied with high tem-
perature, 5 mm Neoceram ceramic glass that
will withstand the highest heat that your unit will
produce. If your glass requires cleaning, we
recommend using an approved glass cleaner
available at all authorized dealers. Do not use
abrasive materials. Do not clean the glass when
hot.
In the event that you break your glass by impact,
purchase your replacement from an authorized
Masport dealer only, and follow our step-by-
step instructions for replacement.
WARNING: Do not operate the ap-
pliance with the glass panels re-
moved, cracked or broken. Replace-
ment of the glass panels should be
done by a licensed or qualified serv-
ice person.
Caution: Wear gloves when remov-
ing damaged or broken glass.
Flush Glass Replacement
Remove the flush door front (as per instruc-
tions on page 24). Remove the 4 glass clips
from each corner. Slide in the new replacement
glass. Push the 4 glass clips back onto the
frame. The glass must have gasketing
around it.
Bay Glass Replacement
1) Remove the door from the unit and place on
a soft surface to prevent scratching.
2) Remove the nuts holding the glass clips in
place and remove.
3) Replace the glass. The glass must have
gasketing around it.
5) Reverse the previous steps, replace the
glass clips and fasten with the nuts but do
not over tighten, as this can break the glass.
6) Replace door on the stove and check the
seal.