22
2. Unscrew and take away the side burner.
3. Using the supplied socket screwdriver, unscrew and remove
the LPG gas jet, leaving the NG jet in place.
4. Reassemble the side burner.
LEAK TESTING
WARNING!
Never use a naked flame to check for gas leaks.
Always use the following procedure to check for gas leaks.
1. In a small container, mix up a solution of water and detergent
or soap.
2. Make sure that the gas supply valve on the gas cylinder is
turned on.
3. Make sure that the gas control valves on the appliance are all
turned off.
4. Using a brush or spray bottle apply the solution to the gas line
and each join in the gas line.
5. Bubbling of the solution will indicate that there is a leak
present.
6. Re-tighten or re-seal any joints that are leaking.
7. If a leak persists then contact your distributor or the
manufacturer for assistance.
When to Test
: The BBQ gas bottle, regulator & hose assembly
should be checked for leaks, using the soapy water leak test, every
time you reconnect your regulator to the BBQ gas bottle. You
should also test after any long period of non-use, such as at the
beginning of BBQ season.
What to use
: You will need a soapy water solution to check for any
leaks. Mixing liquid hand soap with water will work fine (do not use
any other household cleaning products).
How to Test
: Put some soapy water in a spray bottle or a dish.
Turn on the gas bottle but do
not
turn on the BBQ. Next, spray
the entire valve, regulator and hose assembly with the soapy water
including where the hose connects to the BBQ. Alternatively, you
can apply the soapy water with a paint brush, basting brush.
Bubbles will form if there is a gas leak and you may also smell the
gas. If you find a leak, turn off the gas bottle immediately!
Do not turn back on or attempt to use the BBQ if a gas leak has
