GB - 22
TROUBLESHOOTING
PROBLEM
PROBABLE CAUSE
CORRECTION
Engine will
not crank
1. Ignition switch not in
"RUN" position.
2. Bad starter or wire
connection.
3. Electrical problem
1. Turn key to "RUN" position.
2. Check connections. See your Dealer.
3. Check wiring for wear, damage or poor
connections. See your Dealer.
Engine will
not start
1. Ignition switch not in
"RUN" position.
2. Bad starter or wire
connection.
3. Engine ignition
problem.
4. Fuel tank is empty.
1. Turn key to "RUN" position.
2. Check connections. See your Dealer.
3. See Engine Manual.
4. Fill tank with properly mixed fuel.
Prime engine, set choke for easier
start.
Engine stops
1. Improperly mixed or
contaminated fuel.
2. No spark.
1. Use only clean, properly mixed fuel. If
necessary, drain tank and refill with
new fuel mixture.
2. Check spark plug and connecting wire.
Discharge
chute will not
turn
1. Chute gears are
frozen.
1. Move unit to a warm area to thaw.
Auger will not
turn or throw
snow
1. Auger is frozen in
place.
2. Ice or debris is
obstructing auger.
3. Auger control cable
out of adjustment.
4. Drive belt slipping;
idler out of
adjustment.
1. Move unit to a warm area to thaw.
2. With engine off, and auger
disengaged, check for obstructions
and remove.
3. Adjust cable. See
Service and
Adjustments.
4. Adjust idler. See
Service and
Adjustments.
