Masibus 5002U-P, User Manual

Page: 32 / 35

TEMPERATURE CONTROLLER 5002U-P
REF NO: m55A/om/201
Issue NO: 03
Page 32 of 35
37 PV Scale 40037 Char 0 1 R/W
38
Output
Direction
40038 Char 0 1 R/W
39 Relay Delay 40039 char 0 99 R/W
40 Square root 40040 Char 0 1 R/W
41 Set point Display 40041 Char 1 4 R/W
42 PV Filter 40042 Char 0 60 R/W
43 Slave Device id 40043 Char 1 247 R/W
44 Baud Rate 40044 Char 0 1 R/W
45 Parity/Stop Bit 40045 Char 0 3 R/W
46
Retransmission 1
Type 40046 Char 0 4 R/W
47
Retransmission 1
Direction 40047 Char 0 1 R/W
48
Retransmission 1
Range high 40048 Integer -5.00% 105.00% R/W
49
Retransmission 1
Range low 40049 Integer -5.00% 105.00% R/W
50
Retransmission 1
Range span 40050 Integer -1999 9999 R/W
51
Retransmission 1
Range zero 40051 Integer -1999 9999 R/W
52
Retransmission 2
Type 40052 Char 0 4 R/W
53
Retransmission 2
Direction 40053 Char 0 1 R/W
54
Retransmission 2
Range high 40054 Integer -5.00% 105.00% R/W
55
Retransmission 2
Range low 40055 Integer -5.00% 105.00% R/W
56
Retransmission 2
Range span 40056 Integer -1999 9999 R/W
57
Retransmission 2
Range zero 40057 Integer -1999 9999 R/W
58 Time out 40058 Char 10 100 R/W
59 Lock
– 1 (Level-1)
40059 Char 0 1 R/W
60 Lock
– 2 (Level-2)
40060 Integer 0 1 R/W
61 Lock
– 3 (Level-3)
40061 Integer 0 1 R/W
62 Lock
– CAL
40062 Char 0 1 R/W
63 Password 40063 Integer 0 9999 R/W
64 Inhi 40064 Integer >Inlo value
Maximum
Input Value R/W
65 Inlo 40065 Integer
Minimum
Input Value <Inhi value R/W
NOTE:-
1. Modbus function code 06 is used to preset single register but it is user
responsibility to preset appropriate register because through keyboard few
parameters are disabling according to the configuration set by user but Modbus
will display all these parameters when user read through Modbus function code
04.