Masibus 5002U-P, User Manual

Page: 24 / 35

TEMPERATURE CONTROLLER 5002U-P
REF NO: m55A/om/201
Issue NO: 03
Page 24 of 35
8. ALARMS
For all Alarm there are five settings. (As shown in LEVEL
– 1 Menu)

Set Value

Type

Hystresis

Direction (Normal/Fail safe)

Delay

Latch
SET VALUE: Alarm set point
ALARM TYPES: Various alarm operations are shown in the reference figure.
ALARM
TYPE
NO
Display
message
ALARM TYPE
Note
0
none
None
NO operation
available
1
P .D .H .C
Deviation High control Ref figure 3
2
P .D .H .A
Deviation High alarm Ref figure 3
3
P .D .L .C
Deviation Low control Ref figure 4
4
P .D .L .A
Deviation Low alarm Ref figure 4
5
P .D .R .C
Deviation High & Low Range control Ref figure 5
6
P .D .R .A
Deviation High & Low Range alarm Ref figure 5
7
P .D .B .C
Deviation High & Low Band control Ref figure 6
8
P .D .B .A
Deviation High & Low Band alarm Ref figure 6
9
P .A .H .C
Absolute value High control Ref figure 1
10
P .A .H .A
Absolute value High alarm Ref figure 1
11
P .A .L .C
Absolute value Low control Ref figure 2
12
P .A .L .A
Absolute value Low alarm Ref figure 2
13
SP .A .H
Absolute value set point high alarm Ref figure 7
14
SP .A .L
Absolute value set point low alarm Ref figure 8
15
P .S .D .H
Deviation High alarm with standby Same as figure 3
16
P .S .D .L
Deviation Low alarm with standby Same as figure 4
17
P .S .D .R
Deviation High & Low Range alarm
with standby
Same as figure 5
18
P .S .D .B
Deviation High & Low Band alarm with
standby
Same as figure 6
19
P .S .A .H
Absolute value High alarm with
standby
Same as figure 7
20
P .S .A .L
Absolute value Low alarm with
standby
Same as figure 8
21
PV-E
PV error(OPEN/OVER/UNDER) Note 1
22
PRVE
Any type of error Note 1
Note: In case of alarm, relay can be resetted with application of acknowledge key
NOTE-1: The fault diagnosis output turns on in case of input burnout (PV) failure.
Table 8.1