2
52
Understanding the Vehicle
WARNING!
•
Your motorized door or gate will open
and close while you are programming
the universal transceiver. Do not
program the transceiver if people, pets
or other objects are in the path of the
door or gate. Only use this transceiver
with a garage door opener that has a
“stop and reverse” function. Do not
use a garage door opener without
these safety functions. Call toll-free
1
–
800
–
355
–
3515 or, on the Internet
at www.HomeLink.com for safety
information or assistance.
•
Vehicle exhaust contains carbon
monoxide, a dangerous gas. Do not
run your vehicle in the garage while
programming the transceiver. Exhaust
gas can cause serious injury or death.
Before You Start Programming
HomeLink
®
Be sure that your vehicle is parked
outside of the garage before you begin
programming.
For more efficient programming and
accurate transmission of the radio-
frequency signal it is recommended that
a new battery be placed in the hand-held
transmitter of the device that is being
programmed to the HomeLink
®
system.
Before starting programming it is
necessary to erase the standard codes
memorized on the HomeLink
®
device
during the production phase. To erase
such codes:
•
place the ignition device in
ON
position
without starting the engine;
•
press and hold the two outside
HomeLink
®
buttons (I and III) until the
warning light starts flashing (after
approximately 20 seconds);
•
release the buttons.
NOTE:
•
Erasing the standard codes should only
be performed when programming
HomeLink
®
for the first time. Do not
perform this operation to program
additional buttons.
•
If you have any problems, or require
assistance, please call toll-free
1
–
800
–
355
–
3515 or, on the Internet at
www.HomeLink.com
for information or
assistance.
System with Devices Provided
with Rolling Codes
Programming the Hand-held
Transmitters Manufactured after 1995
These devices can be identified by the
“LEARN” or “TRAIN” setting button
located where the hanging antenna
is attached to the garage door/gate
opener. It is NOT the button that is
normally used to open and close the
door.
The name and colour of the button may
vary by manufacturer.
•
Place the ignition device to
ON
position
without starting the engine.
•
Place the hand-held transmitter 5 -
30 cm (1 to 3 inches) away from the
HomeLink
®
button you wish to program.
•
Simultaneously press the Homelink
®
button you want to program and the
hand-held transmitter button.
•
Release immediately the Homelink
®
button you want to program.
•
Continue holding the hand-held
transmitter button until the warning
light starts flashing quickly; then
release the button.
The quick flashing light indicates that
the channel with the new frequency
has been acquired and programmed
correctly by the HomeLink
®
system.
NOTE:
The distance necessary between the
portable hand-held transmitter and the
HomeLink
®
in the vehicle depends on the
system you wish to program. Probably
it will be necessary to try several times.
Upon every attempt, keep the setting
position for at least 15 seconds before
trying again.
Summary of Contents for Grecale 2022
