Maserati Grecale 2022, Owner'S Manual

Page: 258 / 324

7
256
In an Emergency
NOTE:
The compact spare wheel is supplied in
aluminium or steel: the pictures show
the one in aluminium.
The compact spare wheel is stored
in the boot and is supplied deflated
in order to limit the amount of space
occupied. An electric compressor is also
provided for inflating. In the event of a
tire puncture, proceed as follows.
• Stop the vehicle in a place that does
not constitute a danger to traffic and
where the wheel can be changed
safely. The vehicle must be level and on
firm ground.
• Select the P (Park) mode and then
engage manually the electric parking
brake and move the ignition device to
STOP position.
• If necessary, turn the hazard warning
lights on and place the warning triangle
(if equipped) at the required distance.
WARNING!
• The jack should be used on level firm
ground wherever possible.
•
It is recommended that the wheels of
the vehicle be chocked, and that no
person should remain in a vehicle that
is being jacked.
•
If the vehicle has been stopped on
a slope or an uneven surface, place
chocks or other suitable items in front
of or behind the wheels to stop the
vehicle from moving.
• Never start or run the engine with the
vehicle on a jack.
• No person should place any portion
of their body under a vehicle that is
supported by a jack.
• Release the straps that anchor the
compact spare wheel bag to the boot
compartment floor.
• Remove the bag from the boot
compartment.
• Lift the ground coverage of the boot
compartment.
• Remove the compressor from the
preformed container.
• Remove the compact spare wheel and
other tools from inside the bag.
Compact Spare Wheel Installation
• Extend the spanner as shown, then
loosen anticlockwise by approximately
one turn the five bolts on the wheel to
be changed. In case a wheel security
stud bolt is installed, it can only
be removed by using the specific
fitting spanner insert provided with
the “Wheel Security Stud Bolt Kit”,
available in the “Genuine Accessories”
range. In this case, the insert must be
installed on the kit spanner.