Maserati Grecale 2022, Owner'S Manual

Page: 310 / 324

8
308
Maintenance and Care
To minimize the possibility of scratching
the lenses and reducing light output,
avoid wiping with a dry cloth. To remove
road dirt, wash with a mild soap solution
followed by rinsing.
Do not use abrasive cleaning
components, solvents, steel wool or
other aggressive material to clean the
lenses.
Condensation and Fogging on the Light
Clusters
With cold or humid climate, after
a driving rain or after cleaning the
car, the surface of the front and rear
light clusters could fog and/or form
condensate drops on the inside. This
is a natural phenomenon due to the
temperature and humidity difference
between the lens internal and external
surface, which nevertheless does
not indicate a fault and does not
compromise the regular operation of the
lights.
The fogging/condensate disappear
when switching on the lights, starting
from the centre of the diffuser and going
gradually to the edges.
Mouldings and Aluminium Trims
• For cleaning mouldings and aluminium
trims, avoid the use of acidic or
alkanline cleaning agents that can
destroy the protecting surface
treatment.
• After washing aluminium trim with
warm water, apply the cleaning agent
with a clean tissue or a soft sponge
on the surface. Do not use any other
equipment such as brushes, steel wool,
abrasives or any other equipment for
cleaning.
• After cleaning, please rinse the
aluminium trim with a lot of clear water.
• While cleaning in the car wash please
make sure that the mouldings and
aluminium trims only gets contact with
soft brushes or textiles.
Engine Compartment
At the end of each winter season,
carefully wash the engine compartment,
remembering to avoid directing the jet of
water for too long on the electric parts.
To perform this operation, you must
contact the
Service Network .
“Car Wash” Mode
To move the vehicle in tunnel washers,
or generally move with engine off, you
can use the following mode.
• Vehicle must be on level ground,
stationary or moving up to 1 km/h (0.6
mph).
• Move the transmission in N (Neutral)
mode.
• The brake pedal pressed or not
pressed.
• Turn the engine off by pressing the
START/STOP button.
Through these steps, the driver's door
must be closed. This condition will
persists for about 15 minutes, the
transmission will switch to P (Park)
mode once time has expired.
In case of low-battery voltage the
transmission can be placed in P (Park)
mode before this time has expired.
NOTE:
If the driver wants to leave the
vehicle, the EPB should be released
if automatically applied leaving the
vehicle.
WARNING!
• The vehicle will always stay in N
(Neutral) mode during this procedure
without pressing the brake pedal.
To avoid accidental movement,
always check that the movement of
the vehicle take place only on a flat
surface.
• DO NOT USE this mode to haul the
vehicle because after a period of
time the transmission will be set
automatically in P (Park) mode. If this
occurs when the vehicle is moving the
transmission can be damaged.