Mase I.S. 24, Use, Maintenance And Installation Manual

Page: 82 / 94

IS 24 - 27 - 25T - 30T - 34T
- 36
GB
GB
1
2
5
6
7
8
9
6.6 R
EPLACING
/ C
LEANING
T
HE
F
UEL
P
UMP
F
ILTER
This operation is carried out following the steps below:
- Remove the pipe (ref.1)
- Slide out the filter (ref.2)
- Clean or replace it
For reassembly repeat the operations in reverse order.
After replacing the filter, the fuel system has to be bled
by carrying out the operations described in par 6.10.
6.7 R
EPLACING THE LINE FUEL FILTER
This operation is carried out following the steps below:
- Close the fuel faucet (ref.3)
- Unscrew the support ferrule (ref.4) completely
- Remove the old cartridge and replace with a new one.
For reassembly repeat the operations in reverse order.
6.8 D
RAINING OF THE OIL
/
WATER SEPARATOR
Drain off the oil/water separator whenever there is a lot
of drain collected in the oil/water separator at the bottom
of the cup even if not the time for periodic inspection
hour.
The cup of the oil/water separator is made from
semitrasparency material and in the cup, the red colored
float ring which rises on the surface of the drain is installed
to visualize the amount of drain.
Drain off the oil/water separator in the following manner:
1) Prepare a waste oil container
2) Close the fuel cock
(ref.5)
3) Loosen the drain cock at the bottom of the oil/water
separator (ref.6) , and drain off any water collected
inside.
4) Tighten the drain cock with hand.
5) Be sure to bleed air in the fuel system.
6.9 C
LEANING OIL
/
WATER SEPARATOR
Periodically wash the oil/water separator element and
inside cup with clean fuel oil.
1) Prepare a waste fuel container
2) Close the fuel cock
(ref.5)
3) Loosen the drain cock (ref.6) and drain
4) Turn the retaining ring (ref.7) counter-clockwise and
remove the cup (ref.8) . (Keep the float ring (ref.9) at
hand).
5) Wash the element and inside cup with clean fuel oil.
Replace the element with new one if any damaged.
Do not let the skin come into contact with the fuel.
During maintenance operations wear protective gloves
and glasses.
In the event of accidental contact with fuel, thoroughly
and immediately wash the affected part with soap and
water.
When the operation has been completed, thoroughly
clean off any traces of fuel and dispose of the used
cloths at special Collection Centres.
TANK
GENERATOR