6
P/N 27740
10/11
WaLL sEt INstaLLatIoN (Continued)
9. Mark Panel Height
Side
flange
Top flange
Top flange
◘
Check that vertical side panel flanges are straight and
square to base.
◘
Using a pencil, mark panel height on all wall studs.
10. Apply Adhesive and Sealant
Back panel
support
◘
Remove and disassemble panels.
TIP: Pressure may be required to disengage hooks from
slots.
APPLY ADHESIVE
to back panel support.
APPLY SEALANT
along back of base.
11. Secure Back Panel
Top flange
Shim
Less than
1/8" gap
1-1/4" screws
(panhead or roundhead)
◘
Press back panel in place.
IMPORTANT!
Gaps between fl anges and studs must be
less than 1/8". Insert shims to fi ll gaps.
◘
Secure top flanges to studs with 1-1/4" screws.
CAUTION:
Use panhead or roundhead screws. Do not
overtighten screws, this can cause panel to crack.
12. Apply Adhesive and Sealant
Pencil line
APPLY SEALANT
along side of base and back panel as
shown.
APPLY ADHESIVE
to studs.
