7
English
Engine will start.
After pulling starting rope gently by two or three
times, pull it hard to start the engine.
[Pulling method for starting rope]
1. Grasp starting rope tight with right hand.
2. Hold chemical tank with left hand.
3. Pull starting rope slowly until resistance is felt.
4. Pull starting rope straight from entrance of
starter.
5. Do not pull starting rope to the end.
6. Do not release the starter rope handle when
rope is extended. Allow the recoil to rewind the
rope gradually.
5
If the engine does not start by repeated action,
try pulling the rope after fully opening the choke.
CAUTION
※
If the engine still does not start, refer to
page 10.
Return choke slowly.
6
Operating instructions
CAUTION
・
When starting the engine, make sure to put water or chemicals into the
chemical tank. Without water or chemicals in the tank, the pump will break
down. Never run the pump dry.
・
It is confirmed that the ball cock has closed before it starts.
Perform priming.Push priming pump installed
in front of the carburetor several times slowly,
and confirm that fuel fills the priming pump
and returns to the tank through the clear
return line.
1
Fully close the choke. (In hot weather or
when engine is hot, the choke should be
partly open or fully open.)
2
Move throttle lever to medium-and low-
speed position.
3
Set handle of pressure control valve at
"STARTING" position.
4
STARTING
HERBICIDE
HIGH
PRESSURE
INSECTICIDE
Throttle lever
H
L
Close
