-
19
-
Cutting Blades
1. Use only the correct blade (MARUYAMA genuine part) approved for the application and model Brushcutter.
2. Carefully check the condition of the blades before and after operation.
3. Sharpen dull blades. Replace any blade that is worn, cracked or damaged.
4. If a blade produces eccentric rotation or vibration, replace the blade and the boss adapter with MARUYAMA
genuine parts.
MC-E(Multi-Cutter with Edger Attachment)
Operating Position
Before using the Multi-Cutter with Edger Attachment, check the following:
1. The unit should be on the operator’s right side.
2. The operator’s right hand should be holding the shaft grip,
with his or her fingers on the throttle trigger. The right arm
should be slightly bent.
3. The left hand should be holding the loop handle with the
fingers and thumb fully enclosed around the grip. The left
arm should be extended. Reposition the loop handle up or
down the driveshaft if necessary for a comfortable position.
4. The Edger weight should be evenly distributed between the arms.
5. Adjust the Edger to the correct cutting depth before you start the engine. (Refer to Setting Depth of Cut
on this page) Make sure the blade guard is adjusted to shield the operator from thrown debris.
6. Make sure the blade is rotating (at least half throttle) before inserting the blade into the cut. The Edger
performs best at full throttle.
7. Always release the throttle trigger and allow the engine to return to idle speed when not cutting.
8. Stop the engine when moving between work sites.
Blade Guard
Direction of Travel
WARNING
POTENTIAL HAZARD
・
Foreign objects can be thrown by Edger Attachment.
WHAT CAN HAPPEN
・
Contact with thrown objects can cause personal injury.
HOW TO AVOID THE HAZARD
・
Never operate the Edger Attachment without the blade guard in place.
・
Make sure the blade guard is correctly positioned to shield operator from thrown debris.
CAUTION
・
Read the Safety instructions beginning on page 2 concerning proper use of the Multi-Cutter.
