D O NOT USE FUEL ADDITIVES OTHER
THAN THOSE MANUFACTURED FOR
FUEL STABILIZATION DURING STORAGE
SUCH AS MARUYAMA'S STABILIZER/
CONDITIONER OR A SIMILAR PRODUCT.
MARUYAMA'S STABILIZER/CONDITION
ER IS A PETROLEUM DISTILLATE BASED
CONDITIONER/STABILIZER.
MARUYAMA DOES NOT RECOMMEND
STABILIZERS WITH AN ALCOHOL BASE
SUCH AS ETHANOL, METHANOL OR ISO
JPROPYL. ADDITIVES SHOULD NOT BE
USED TO TRY TO ENHANCE THE POWER
OR PERFORMANCE OF MACHINE.
Mixing Gasoline And Oil
IMPORTANT: The engine used on this
Multi Cutter is of a 2-cycle design. The internal
moving parts of the engine, i.e., crankshaft
bearings, piston pin bearings and piston to
cylinder wall contact surfaces, require oil
mixed with the gasoline for lubrication.
Failure to add oil to the gasoline or failure to
mix oil with the gasoline at the appropriate
ratio will cause major engine damage which
will void your warranty.
For your fuel premix, use Maruyama Premium
2-cycle Oil
Mix,
or equivalent ISO-L-EGD
&
JASO FD oil with a minimum 89 octane high
Quality gasoline. Maruyama 2-cycle oil is spe
cially formulated to meet the requirements of
high-performance, low-emission air-cooled 2-
cycle engines. Use of other oils may lead to ser
vice
issues
which may Not be covered by your
warranty.
Fuel Mixture
The fuel: oil ratio is 50 parts gasoline to I part oil or
50:1.
50:1
Note:
Never use a mixing ratio less than
50:1 regardless of the oil package
mixing instructions. Ratios less than
50:1, (for example, 60:1, 80:1, 100:1),
reduce the amount of lubrication to
the internal moving parts of the
engine and can cause damage.
Fuel Mixture Chart
Gasoline
50:1 2-cycle oil
1 gallon
2.6 oz.
2 gallons
5.1 oz.
5 gallons
12.8 oz.
1 litre
20ml
5 litre
100 ml
Mixing Instructions
IMPORTANT: Never mix gasoline and oil
directly in the Multi - Cutter fuel tank.
I.
Always mix fuel and oil in a clean container
approved for gasoline.
2. Mark the container to identify it as fuel mix for
the Multi - Cutter.
3.
Use regular unleaded gasoline and fill the contain
er with half the required amount of gasoline.
4. Pour the correct amount of oil into the container
then add the remaining amount of gasoline.
5. Close the container tightly and shake it momentar
ily to evenly mix the oil and the gasoline before
filling the fuel tank on the Multi - Cutter.
6. When refilling the Multi - Cutter fuel tank, clean
around the fuel tank cap to prevent dirt and debris
from entering the tank during cap removal.
7. Always shake the premix fuel container momen
tarily before filling the fuel tank.
8.
Always use a spout or funnel when fueling to
reduce fuel spillage.
9. Fill the tank only to within 1/4-1/2 inch (6 mm-13
mm) from the top of the tank. Avoid filling to the
top of the tank filler neck.
-US-25-
