...-- Screw 6 mm (2)
i
/
Bracket
Gearcase
�
Plastic Collar
\ Onelnch
"
\
y-·-4"1?..--Ends
Screw 5 mm (4)
Connecting the Tool Attachments
to the Power Unit
First, loosen the clamping knob so the shaft of the tool
attachment can be inserted into the tube coupler. Pull
the detent knob outward and gently rotate the attach
ment shaft back and forth while inserting to be sure the
drive-
shafts completely in place. The spring-loaded detent
knob will snap into place when the attachment shaft is
correctly positioned. Tighten the clamping knob. When
changing the tool attachment be careful not to over
loosen the clamping knob to prevent it from falling.
Tube coupler
Detent Knob
Before Operation
Chain Oil {Multi-Cutter with Pruner
Attachment)
The chain and guide bar are lubricated by a centrifugal
pump. The oil discharge rate is controlled by the oil
discharge adjustment screw on the top of the pruner
head.
Remove the oil tank filler cap fill the tank, then replace
the cap.
"
11....,,
Oil Tank Filler Cap
Oil Discharge
Adjustment Screw
IMPORTANT: Only use oil designed for lubricating
chain saw chains and guide bars. Do not use waste
oil. Never run the chain dry. In temperatures below
freezing, check the chain oil viscosity (pour point).
If
the oil is not rated for use below freezing, it may not
provide adequate lubrication, resulting in damage
to the oil pump, chain and guide bar.
IMPORTANT: When filling the oil tank for the first
time, or when the tank is completely empty, wait
approximately 60-90 seconds before starting the
Pruner. This will give the oil time to flow from the
tank to the pump. Otherwise, an air lock can occur
which will prevent oil from moving through the
pump. This will result in damage to the chain and
guide bar.
-US-23-
