Before using the Trimmer, check the following:
l.
The Trimmer should be on the operator's right
side.
2.
The operator's right hand should be holding the
shaft grip, with his or her fingers on the throttle
trigger. The right arm should be slightly bent.
3.
The left hand should be holding the loop handle
with the fingers and thumb fully enclesed around
the grip. The left arm should be extended.
Reposition the loop handle up or down the drive
shaft if necessary for a comfortable position.
4.
11te Trimmer weight should be evenly distributed
between the arms. The trimmer head should be
near and parallel to the ground.
5.
Accelerate and hold the engine at cutting speed
before entering the material to be cut.
6.
Always release the throttle trigger and allow the
engine to return to idle speed when not cutting.
7.
Stop the Trimmer engine when moving between
work sites.
A
CAUTION
• Always wear gloves and protective cloth
ing when operating the String Trimmer.
If the trimmer head becomes jammed, stop the
engine immediately.
• Make certain all moving parts have stopped · and
disconnect the spark plug before inspecting the
equipment for damage.
• Never use a String Trimmer that has chipped,
cracked or broken trimmer head.
Cutting with Nylon Trimmer Line
• The tip of the line does the cutting. The line
should stay extended while cutting.
• Do not force the line into the material. Forcing
the line will cause _it to slap against the material,
increasing line usage and causing poor cutting
results.
INCORRECT
Trimming
Hold the bottom of the trimmer head about 3 in. (7.6
cm) above the ground and at an angle. Allow only the
tip of the line to make contact.
-18-
