Maruyama BC2300, Owner'S/Operator'S Manual

Page: 9 / 29

Assembly·
Assembling Engine and Drive
Shaft Assembly
The drive shaft, clutch drum housing and gearcase are
assembled. Attach the clutch drum housing to the
engine using the four MS x 20 screws supplied with the
unit.
·Engine
/ M5x20Screw(4)
Shaft
I. Slip the rubber sleeve around the shaft approxi­
mately 9 inches (22.8 cm) from the end of the stop
switch/throttle trigger assembly for an initial han­
dle position.
2.
Rotate the rubber sleeve so the split is to one side.
3. Place the loop handle and the bottom clamp over
the rubber sleeve.
4. Install the four screws and nuts. Leave the screws
finger-tight.
5.
Reposition the loop handle up or down the drive
shaft to the most comfortable position, but no
closer than 9 inches (22.8 cm) from the end of the
[Models: BC2300, BC2600, BC3200]
stop switch.
Loop Handle Installation
The loop handle kit contains a package of four screws
and nuts, a rubber sleeve and the bottom clamp for the
loop handle.
Screw (4)
Rubber Sleeve
Bottom Clamp
-8-
6.
Tighten the screws and nuts.
[Models: BC2600H, BC320DH]
Bullhorn Handle Installation
JMPORTANT: Be careful
not to
damage the
throttle cable and stop switch wires when you
remove the bullhorn handles from the shipping
carton.