I . Loosen the four screws on the top of the clamp bracket.
2.
Insert the left and right bullhorn handles into the
clamp bracket. Note that the bullhorn handle with
the throttle trigger and stop switch goes on the
right-hand side of the Brushcutter.
3.
Adjust the bullhorn handles to the desired posi
tion, then tighten the four screws.
Connecting Stop Switch Wires
Stop Switch Wlres
Stop Switch Wires�
Throttle Cable�
Air Cleaner Cover
Knob
[Models: BC2300, BC2600, BC3200]
1.
Install the plastic tube (packed with the drive shaft
assembly) around the throttle cable and stop.
switch wires.
[All models:]
2.
Loosen the knob and remove the air cleaner cover
to access the stop switch wires.
3.
Plug lhe stop switch wires into the matching con
nectors from the engine. Note lhat wire polarity is
not important.
Connecting Throttle Cable
Cable Adjuster Sleeve
Throttle Cable Housing
Locknut
Carburetor Bracket/
·
Throttle Cable
Slotted RIiing
Recessed
Hole
Cable
Lug
Carburetor Throttle Cam
Throttle Stop/Idle Speed
Cabla Adjuster Sleeve
'\,.I I -::::::,
Adjuster Screw Brar:ket
Idle Speed
Adjuster Screw
Stetted Fitting
1.
With the air cleaner cover removed, insert the
throttle cable through the cable adjuster sleeve on
the carburetor bracket. Make sure the end of the
cable housing is seated positively in the sleeve.
-9-
