Martin Mania DC2, User Manual

Page: 7 / 24

Installation 7
I
NSTALLATION
2
A C P O W E R
Before operation ensure that factory setting of voltage and frequency
match local power supply.
Always ground (earth) the fixture electrically.
Use only a source of AC power that complies with local building and
electrical codes and has both overload and ground-fault protection.
Note: If the external power cord of this luminaire is damaged, it
shall be replaced by a special cord exclusively available from
your Martin dealer.
C o n f i g u r i n g f o r l o c a l m a i n s p o w e r
The Mania DC2 has a switch-selectable power supply that can operate in
the following voltage ranges at 50-60 Hz:
• 115 - 120 volts (setting 115)
• 220 - 240 volts (setting 230)
Warning Do not operate the fixture on a power supply that falls outside
of these ranges.
Select the operating range using the AC supply switch at the rear of the
fixture.
AC supply setting