Martin Mania DC2, User Manual

Page: 17 / 24

Basic service 17
4 Grasp the old lamp by the reflector and slide it carefully out of the lamp
holder.
5 Pull the socket off the lamp. Do not pull the wires.
6 Push the socket fully onto the pins of the new lamp.
7 Clean the glass bulb and reflector with a cloth, particularly if your fingers
touched the glass. A clean, lint-free cloth wetted with alcohol is best.
8 Gently push the lamp into the holder until it snaps into place.
9 Close the fixture cover and tighten the thumb screw.
M A I N S F U S E
The Mania DC2 uses a time-delay fuse for protection against current
overload. An indication that the fuse may have blown is that when power
is applied and the lamp is switched on, no light is produced.
If the fuse blows repeatedly, there is a fault with the unit that requires
service by a Martin technician.
Never bypass the fuse or replace it with one of another size or rating.
R e p l a c i n g t h e m a i n f u s e
1 Unplug the mains cable from the input socket and allow the fixture to cool
for 5 minutes.
2 Pry open the fuse holder (located next to the mains power connector) with
a flat-head screwdriver and remove the fuse.
3 Replace the fuse with one of the same type. The fuse rating is listed on
the serial number label and in “Specifications” on page 19.
4 Replace the fuse holder.