16
Optional accessories (Magnum 850 only)
The timer is now programmed to one-shot mode and this will be remembered
even after the unit has been switched off.
To produce a timed burst of fog, press the FOG button briefly. To stop the timed
fog output early, press the FOG button briefly again.
D i s a b l i n g t i m e r m o d e
If you wish to simplify the remote control, you can disable the timer function.
This means that a short press on the FOG button will just produce a short burst
of fog and the timer will not be enabled.
1.
Press the TIMER SET button once. The ON light flashes.
2.
Turn the knob fully left to the “OFF” section.
3.
Press the TIMER SET button again.
The zero times will be stored, disabling the timer. This will be remembered even
after the unit has been switched off. The ON and OFF lights remain off when the
timer is disabled.
To re-enable the timer function, store some non-zero times as described above.
M e a n i n g o f r e m o t e c o n t r o l l i g h t s
The four lights on the remote have the following functions. The red “HEAT” light
and the green “READY” light are also duplicated on the top of the machine itself.
HEAT+READY meaning
no lights
Machine is not powered, or remote is not connected
heat
Machine is heating but is not yet up to operating
temperature
heat + ready
Machine is heating and has reached minimum operating
temperature. Fog output level may be reduced while
heating.
ready
Machine has finished heating and is at full operating
temperature
OFF+ON meaning
no lights
Timer is disabled
both on
Timer is programmed but not enabled
“OFF” lit
Timer is running, currently in Off/Wait period
“ON” lit
Timer is running, currently in On/Run period
“ON” flashing
The timer “ON” time is currently being programmed
“ON” lit, “OFF”
flashing
The timer “OFF” time is currently being programmed
