Onboard control menus
35
Adjustment submenu
This menu is accessed under
ADJ
in the
SERV
service menu. Adjustments are for service use only.
FACT
FACT
LOAD
Return all settings (except calibrations) to factory defaults
NB: can take up to 2 minutes to complete!
CUS1,
CUS2,
CUS3
LOAD
Load custom configuration
SAVE
Save current custom configuration
DMXL
RATE
DMX transmission speed, live, in packets per second
QUAL
Percent of packets received with errors, live
STRT
Decimal value of the DMX start code, live
SERV
To access
this menu,
hold
[Enter]
pressed for
a few
seconds
PTFB
ON
Enable pan/tilt position feedback/correction system
OFF
Disable pan/tilt feedback (this setting is not saved when fixture is reset)
ADJ
Effects adjustment menu (for service use: for full details of this menu,
see “Adjustment submenu” below)
CAL
(OF = offset)
P OF
Pan calibration
T OF
Tilt calibration
DOF
SURE
Load factory effects calibration settings
PCBT
SURE
PCB test: for service use only
UPLD
SURE
Manually set fixture to receive software upload
HEAD
DUAL
Sets head to dual head module operation
SNGL
Sets head to single head module operation
ADJ
RSET
Reset fixture
HEAD
RED
Red – 0%/50%/100%
GRN1
Green 1 – 0%/50%/100%
GRN2
Green 2 – 0%/50%/100%
BLUE
Blue – 0%/50%/100%
ZOOM
Zoom – 0%/50%/100%
P-T
NEUT
Pan and tilt in neutral (centered) positions
PNTD
Pan neutral, tilt down
PNTU
Pan neutral, tilt up
PLTN
Pan left, tilt neutral
PRTN
Pan right, tilt neutral
PLTD
Pan left, tilt down
PRTU
Pan right, tilt up
Table 7: Adjustment submenu
Menu
Item
Options
Notes (Default settings in bold print)
Table 6: Control menu: dual head module operation, REAR menu