10
MAC 401 Dual™ user manual
Attaching a cable to the male input connector
To attach a power cable to the supplied input connector:
1. Slide the bushing over the cable.
2. Slide the white chuck over cables with a diameter (D
a
) of 5 - 10 mm
(0.2 - 0.4 in.), or the black chuck over cables with a diameter of 10 -
15 mm (0.4 - 0.6 in.).
3. Prepare the end of the cable by stripping 20 mm (0.8 in.) of the
cable’s outer jacket.
4. Strip 8 mm (1/3 in.) from the end of each of the wires.
5. Insert each of the wire ends into the appropriate terminal (see
Table 1 above) and fasten the clamping device using a small
flathead screw driver.
6. Push and insert the chuck into the housing (note that there is a
raised key on the chuck to ensure that it is oriented correctly).
7. Fasten the bushing, using a wrench, to a torque of 2.5 Nm (1.8
lb-ft).
Illustrations on this page used by kind permission of Neutrik AG.
Chuck
Bushing
Housing
Insert
Cable end
Terminals