Setup
13
Setup
Warning! Read “Safety Information” on page 3 before installing, powering, operating or servicing
the MAC 401 Dual™.
Control panel and menu navigation
The onboard control panel and LED display are used to set the MAC 401 Dual™’s DMX address, configure
individual fixture settings (personality), read out data and execute service utilities. See “Onboard control
menus” on page 30 for a complete list of menus and commands.
Using the control buttons
See Figure 4.
• Press [Menu] to enter a menu, to escape a function or move back one level in the menu structure.
• Press the [Up] and [Down] buttons to scroll within a menu or increase and decrease values.
• Press [Enter] to enter a submenu or activate a function. Note: [Enter] must be pressed and held for a few
seconds to enter the Service menu (
SERV
).
Control menu shortcuts
• Hold [Menu] and press [Up] - Resets fixture
• Hold [Menu] and [Enter] during fixture reset - Freezes pan and tilt
• Hold [Up] and press [Down] - Inverts display for easy reading when the fixture is suspended base up.
Display functions
The DMX address is shown in the display panel when the MAC 401 Dual™ is powered on and has reset.
By default the display is set to go into to sleep mode 2 minutes after the last key press. To reactivate the
display, press any key. To modify or disable this setting see “Display settings” on page 16.
Figure 4: Control panel and display
A
B
C
D
E
F
G
A – Four-character LED display
B – Service indicator LED
C – DMX input indicator LED
D – UP button
E – ENTER button
F – DOWN button
G – MENU button