Safety Information
3
Safety Information
The following symbols are used to identify important safety information on the product and in this manual:
This product is for professional use only. It is not for household use.
This product presents risks of severe injury or death due to fire hazards, electric shock and falls.
Read this manual
before installing, powering or servicing this product, follow the safety precautions listed
below and observe all warnings in this manual and printed on the product.
If you have questions about how to operate the fixture safely, please contact your Martin supplier or call the
Martin 24-hour service hotline on +45 8740 0000, or in the USA on 1-888-tech-180.
P R O T E C T I O N F R O M E L E C T R I C S H O C K
• Connect the product to AC mains power within the range 200 - 240 V nominal at 50 or 60 Hz only.
• Disconnect the entire installation from power and ensure that power cannot be reconnected, even
accidentally, before carrying out any installation or maintenance work.
• Disconnect the product from power when not in use and if you suspect that a fuse has blown.
• Always ground (earth) the product electrically.
• Use only a source of power that complies with local building and electrical codes and has both overload
and ground-fault (earth-fault) protection.
• Connect LC Plus panels to AC power using only 16 A-rated industrial Type B power plugs and socket
outlets that comply with IEC 60309 (or a comparable national standard) and provide an electrical
connection to ground (protective earth).
• Connect LC Plus panels to AC power and to each other using the 16 A rated, UL-listed, 16 AWG cables
supplied by Martin for this product. Replacement power cables from other sources can be used as an
alternative, but they must be 3-conductor Hypalon or neoprene rubber-jacket, approved for a current of
16 A and temperature of 90° C (194° F) minimum. Replacement cables must also be 16 AWG minimum
and UL-listed in North America or have conductor size 1.5 mm² minimum in other regions.
• Socket outlets used to supply LC Plus panels with power or external power switches must be located near
the panels and easily accessible so that the panels can easily be disconnected from power.
• Do not connect any other device than other LC Plus panels to the power output (throughput) connector in
the base of the LC Plus.
WARNING!
Read the safety precautions in this section before
installing, powering, operating or servicing this
product.
Warning!
Safety hazard.
Risk of severe
injury or death.
Warning!
Refer to
manual before
installing,
powering or
servicing.
Warning!
Hazardous
voltage. Risk of
lethal or severe
electric shock.
Warning!
Hot surface. Do
not touch.
Warning!
Fire hazard.
Warning!
Emission
hazardous to
eyesight.
