22
Troubleshooting
Troubleshooting
Problem
Probable cause(s)
Suggested remedy
Machine will not produce
haze when control panel set
to
RUN
or remote control
Haze switch turned on
Machine not at operating
temperature
Wait until
message
no longer shown
set to 0
Increase setting
set to 0
Increase setting
DMX signal present
Disconnect or turn off DMX
controller
Machine can be fired from
control panel or remote
control, but not by DMX
controller
DMX address setting
incorrect
Change DMX address
(page 13)
Poor connection in DMX
line
Check DMX cables and
connections
LINK menu is set to SEND
Set LINK menu to RECV
Haze output is weak
Machine requires priming
Prime machine (page 14)
Wet, greasy, non-uniform
haze output, fluid drips or
spits from nozzle, or very
loud noise when firing
machine
Incompatible haze fluid
Use approved fluid!
Machine appears dead
Mains fuse blown
Replace fuse (page 21)
No power at AC cable inlet
Check power cable and
circuit breaker
Machine causes DMX
errors to occur on other
units when connected to a
DMX system
LINK menu is set to SEND
Set LINK menu to RECV
