12
Control settings
Control settings
O v e r v i e w
The
digital control panel
in the center of the top panel allows you to configure
the machine using option menus.
The machine is factory set so the lower of the ‘Value down/up’
buttons increases a setting. It is possible to change this. Prior to
powering the machine up simply press and hold the button you
wish to use to increase a setting and press the main power
button. Once the display comes on you have successfully
configured your preference. The machine will store this setting
until the above procedure is performed again.
S e t t i n g R u n m o d e
The Run mode sets the operational mode of the unit, either Off, Standby
(heaters remain on), Fan only, Timer mode or Continuous mode.
Use the Menu Previous / Next buttons to select the
option.
Use the Up/Down buttons to select
.
Press the Enter button to store the setting. The display shows
.
Selecting OFF will cause the machine to begin its cleaning cycle ready for power
off, if cleaning is required. This is the same as pressing the Shutdown button on
the rear.
S e t t i n g H a z e d e n s i t y
Use the Menu Previous / Next buttons to select the
option.
Use the Up/Down buttons to select the density from
–
.
Press the Enter button to store the haze setting. The display shows
.
If you want to temporarily change the haze density, do not press
Enter. The haze setting will go back to its stored value next time
the machine is powered up. This applies to all options.
S e t t i n g F a n s p e e d
Use the Previous / Next buttons to select the
option.
Menu previous/next
buttons
Value down/up
buttons
Digital display
Enter/store button
