33
M4082E
ZA
2022-07 CSP1 S
Thoroughly wipe chute wall clean above tensioner.
Place Conveyor Products Warning Label (see above) on outside chute wall
visible to belt cleaner operator.
Additional safety labels are available from CEMA. For more information regarding
CEMA safety labels visit www.cemanet.org.
Start conveyor belt. Observe belt cleaner operation for several revolutions of the
belt. Properly shutdown belt and make appropriate adjustments. Return belt to
service.
Run conveyor belt for one hour or at least 5 turns of the conveyor belt. Adjust
belt cleaner as necessary.
a) Make sure all fasteners are tight. Tighten if necessary.
b) Inspect belt cleaner for the following:
(1) Wear. (A small amount of
“break-in” wear may be found. This
will stop once blades wear to conveyor belt contour.)
(2) Material build-up. (No material between blades and return
side of conveyor belt should be found.)
(3) Ensure the tensioning of the cleaner is in line with the
instructions, re-tension if required.
c) If wear, material build-up, or some other problem exists, see
“Troubleshooting.”
d) Monitor cleaner and after 7
–10 days re-tension cleaner to
overcome any thimble bedding in