F200
6
GB
DESKTOP FOLDER
Figure 7
Figure 6
Figure 4
Figure 5
3. Install the dejamming handle onto the
D-shaped shaft through the hole on the right
side of the folder cover, just above the paper
stop adjustment knob (Figure 5).
4. Depending on the severity of the jam, it may
be necessary to gain access to the jammed
paper through the dejamming door, located
on the bottom of the folder (Figure 6).
To open the dejamming door, carefully apply
finger pressure to the outside of the dejam-
mingdoor locking tabs, which will cause the
tabs to bend inward, releasing the door so it
can be opened.
5. Turn the handle in either direction while care-
fully pulling the paper out of the top or bottom
of the folder.
6. If unable to clear the jam, see the disassem-
bly instructions below.
7. After the jam has been cleared, close the
dejamming door (if open), and return the de-
jamming handle to its storage location on the
bottom of the folder.
Reconnect the wall power supply (Figure 2).
8. If you have not been able to clear the paper
jam by following the previous instructions,
continue to section
DISASSEMBLY IN-
STRUCTIONS
.
DISASSEMBLY INSTRUCTIONS
1. Unplug the wall power supply from the folder.
2. With the folder in an upright position, using a
Philips screwdriver, remove the screw locat-
ed in the center ofthe paper stop adjustment
knob and remove the knob.
3. Inside of the hole where the stop fence ad-
justment knob was removed from will be a
small spring. By tipping the folder on end,
dump out the spring.
4. Using a Philips screwdriver, remove the four
screws nearest to the rubber feet on the bot-
tom of the folder. Carefully return the folder
to it’s normal upright position without allowing
the internal mechanism of the folder to fall out
of the cover.
5. Lift and remove the folder cover.
6. To clear a paper jam, turn the large pulley
on the leftside of the folder in either direction
while carefully pulling the paper from the top
of the folder.
7. To clean the rubber roller, spray
Martin Yale
Roller Cleaner
on a clean, lint-freecloth and
rub the rollers to wipe them clean.
Rotate the rollers by turning the large pulley
in either direction.
Repeat this process until the rubber and steel
rollers are clean and completely dry.
8. Locate and remove both of the roller drive
belts found at either ends of the steel rollers
(Figure 7).
To clean the roller drive belts, place both belts
onto a clean cloth andspray the belts with
Martin Yale Roller Cleaner.
Wipe the belts dry and reinstall.
NOTE:
Use of a cleaner other than
Martin
Yale Roller Cleaner
could damage
the rollers.
UNJAMMING INSTRUCTIONS
1. If paper becomes jammed in the folder,
un-
plug the folder
.
2. From the bottom of the folder, rotate the de-
jamming handle until free and remove the
handle from the folder (Figure 4).
