Martin Professional Inground 200, Installation Manual

Page: 15 / 20

Powering on for the first time 15
connect DMX output cable on the same terminals as the input cable, so that the fixture is
connected to DMX in parallel.
8. Refit the connections compartment cover, being careful not to damage the seal. If the seal shows
any signs of damage or deterioration, the PCB/power compartment cover must also be removed
and the seal must be replaced with a new one (available from Martin Architectural dealers: p/n
20600450).
9. Refit the lamp module, lens and front glass (see “Component removal & reinstallation” on page
17).
7. Powering on for the first time
After all connections and cables are installed, and after the site has been made safe, the Inground
200 can be powered on for testing and beam adjustment.
When fixtures are powered on, lamps strike after a short delay. When programmable Inground 200
models are powered on for the first time, they will run through a factory-set light show for test
purposes. They will continue to run this test sequence until they are programmed.
6 Color model test program
The 6 Color fixture is pre-programmed with 7 scenes, to verify that all colors and the dimmer are
working correctly.
1. White 100% intensity.
2. Color 1 100% intensity.
3. Color 2 100% intensity.
4. Color 3 100% intensity.
5. Color 4 100% intensity.
6. Color 5 100% intensity.
7. White 0% intensity (no light).
Full Spectrum CMY model test program
The Full Spectrum CMY fixture is pre-programmed with 5 scenes, to verify that all color-flags and
the dimmer are working correctly.
1. White 100% intensity.
2. Cyan 100% intensity.
3. Magenta 100% intensity.
4. Yellow 100% intensity.
5. White 0% intensity (no light).
Black: to DMX -
Brown: to DMX +
Shield: to DMX shield
White: to AC neutral
Green: to AC earth/ground
AC power
DMX control data
Black: to AC live