19
Use this setting to enable or disable status display. When enabled, the current video input standard is displayed
on the top left of the screen. When disabled, status is only displayed for 2 seconds when the monitor is powered
on, when an input is applied, or when the input video standard changes. The status display reads “No Input”
when no video input is present.
■
Anc. Timecode
Use this setting to enable time code display on the screen. Time code is de-embedded from the vertical ancillary
data (VANC) within the HD/SDI signal. Two types of time code can be selected to display on the screen:
LTC
(linear time code)
or
VITC (vertical interval time code)
.
The position of the time code display varies based on the aspect ratio setting and presence of IMD text
■
OSD Tally
Use this setting to choose how tally is displayed on the screen. The available OSD Tally options depend on the
Tally Source selected in the IMD Configuration submenu (
see page 22
).
When the Tally Source is set to Standard (contact closure), OSD Tally can be set to
Off
,
RGY
,
RG
, or
GR
:
• Off
On-screen tally is disabled
• RGY
Red, yellow, or green tally signals are indicated at both the bottom left and bottom right corners of the
screen. Two or three colors are shown simultaneously by subdividing each tally indicator
• RG
Red tally is shown at the bottom left of the screen, and green is shown at the bottom right.
• GR
Green tally is shown at the bottom left of the screen, and red is shown at the bottom right.
The following diagrams show RGY, RG, and GR OSD Tally modes:
IMD Text
00:00:00:
IMD Text
00:00:00:
(red)
(red)
IMD Text
00:00:00:
(red)
(green)
(yellow)
(red)
(green)
(yellow)
RGY mode: single color activated
RGY mode: two colors activated
RGY mode: three colors activated
(red)
(gree
n)
(red)
(gree
n)
00:00:00:00
Time Code display
Hours
Minutes
Seconds
Frames
Status Display
