Marol CL-10SET, Installation Manual

Page: 11 / 24

10
•Piping to Cylinder MS Type (Direct-driving type)
90°elbow
High pressure rubber hose
Adapter
Pipe fitting
1. High pressure tube is to be used only for
cylinder side, because Cylinder MS Type
(Direct-driving type) shakes interlocking with
steering.
2. Connect copper tube to Receiving Cylinder
through 90° elbow, high pressure hose,
adapter and pipe fitting.
3. Connect copper tube to pipe fitting same as
the case of Cylinder Rotary type.
Completion of Piping
1. Fix piping by metal fitting for piping as shown
in figure.
Fix pipe by metal fitting every 1
meter for strait line and every 30
cm for curving portion.
2. Once completed the piping works, clean up
all around piping, and flush connectors once
removed.
After flushing, reassemble the connectors.
Caution
Be sure that no dust enter the pip-
ing while flushing.
Make sure not to mistake the direc-
tion of sleeve.
4. Be sure to connect A port of Helm Pump to A
port of Receiving Cylinder, and B port of
Helm Pump to B port of Receiving Cylinder.