Marol CL-10SET, Installation Manual

Page: 3 / 24

2
Warning
For Safety Precautions
Precautions when installing and operating Hydraulic Steering System are explained hereunder.
Warning
As to Thunder
When thunderclap is heard, don't touch
any metal parts of equipments.
Induction of thunder is in danger of getting a shock.
As to Use
During normal operation, be sure to
observe all around the boat and watch
the course.
Caution
Caution
As to Piping
Don't use saw when cutting copper
tubes. Once finished piping works,
clean up all around piping and flush
connectors once removed.
Sawdust and/or fins by saw cutting
may cause poor operation.
Be sure to use pipe cutter and cut the
edges at right angle.
As to Periodical Inspection
Inspect or maintain all the equipment periodically.
Inspection and maintenance should be done periodi-
cally in accordance with Installation Manual.
WARNING shows the assumptive details which may lead
to the possibilities of death or serious injury.
CAUTION shows the assumptive details which may lead
to the possibilities of injury or damage of materials.
As to Helm Pump
Don't install it at the places where it may disturb
the steering.
Accidents may occur, if it will be installed at the
places where it may impede front visibility and
disturb steering.
On the fitting surface, apply caulking materials, if
necessary.
This is for prevention against penetration of
water into inside of boat.
As to Receiving Cylinder Direct-driving type
Install Receiving Cylinder and connect-
ing link of tiller on even level with same
height.
If the connecting link is listed, it may
drop during steering.
Be sure to fasten the locknuts of cylinder
tightly.
After installation or stroke adjustment,
be sure to fasten locknuts tightly.
Otherwise it may cause the falling down
of cylinder.
As to Receiving Cylinder Rotary type
Install Receiving Cylinder and connect-
ing link of tiller on even level with the
same height. If the connecting link is
listed, it may drop during steering.
As to Inspection before Sailing Out
Before sailing out, operate handle and
confirm it to work normally.
Check oil level.