Marmitek SWM1P, User Manual

Page: 14 / 48

© MARMITEK 14
PROGRAMMING
MIND: Switch on power before you start programming. Avoid touching
live parts!
In programming mode the addresses of inputs 1 and 2 (motor address) and
of input 4 (Preset address) can be programmed individually. Also the end posi-
tions of the motor need to be programmed to make them match the position
values of 0% and 100%.
Programming
For programming the module you have to follow the 5 steps below.
1. Switch module to programming mode.
2. Send the motor address.
3. Program the end positions of the motor.
4. Program the Preset address (optional).
5. Leave the programming mode.
These steps are explained.
1. Switch to programming mode
To program the sunblind, it has to be set to the programming mode as follows:
* Push the programming button for at least 3 seconds, see figure 9, when you
release the button the red LED will illuminate.
* Use the automatic programming function of the PRU512.
For this see the manual of the PRU512
Figure 9. Activating and cancelling the programming mode.
P
PROG.
N DN UP
L
SWM1P
PROG.