Combimatic_v2_EN_210315 27
Combimatic
Operation
4 . Loosen the chain pitch wing-nut and move it to
the correct pitch position . Tighten it again .
Note: Adjusting the pitch is not the same thing
as adjusting the cutting tooth length (see section
5 .2 .8, “Set the cutter top plate to equal lengths”) .
5 . Set the chain pusher switch to ON . The chain
pusher arm now advances the chain forward .
6 . Visually make sure that the chain pusher stops
its movement exactly above the rivet behind the
cutting link, as illustrated in the image below .
7 . Set the chain pusher switch to OFF, when the
grinding head is in its uppermost position and
the chain lock is not engaged .
8 . Repeat steps 5–9 until the chain pusher stops
in the correct position .
CAUTION If the pitch is not correctly set,
the chain will be pushed into an incorrect
sharpening position . This may result in a
damaged chain .
