Combimatic_v2_EN_210315 19
Combimatic
Installation
8 . The stand will need to be secured on the floor
through the holes located at the base of the
stand .
Note: The bolts are not provided with the
machine .
9 . After the stand is assembled and secured, bolt
the AC/DC converter to the back of the stand
by aligning the two holes located at the top and
the bottom of the converter to the holes on the
stand .
10 . Next, place the machine on the stand . Fix it to
the stand through the 3 holes located at the
back of the machine with the bolts and nuts
provided .
K
K
K
I
L
J
F
F
11 . To connect the AC/DC converter unit to the
machine, plug in the black and red power cable
into the control panel through the slot on the left
hand side of the machine .
Note: For best performance, use the converter
provided with the machine .
WARNING Put the power converter where
there is as little dust as possible and out of
reach of sparks from the machine .
12 . To connect the air unit, slip the air line that has
been attached to the pneumatic chain tensioner
into the slot marked as “out” at the back of the
machine . Then insert the second airline into the
slot marked “in” . Next, connect the line with the
fitting unit to an air compressor with a pressure
range of 0 .5–0 .8 MPa (5–8 bar) .
WARNING Attach air hoses and cables
with cable clamps to make sure no one trips
over them .
OUT
IN
