36 Combimatic_v2_EN_ 210315
Combimatic
Maintenance and Service
2 . Turn the nut (A) in 1–1 .5 turns clockwise,
until the groove in the chain vise is 1,8-2,0
mm wide in locked position .
Note: This instruction is for 3/4″ chain pitch. For
other chain pitches, adjust to lower numbers .
A
3 . Do a sharpening test and make sure that
the chain remains in its position during the
test . See section 7 .2, “Sharpening test” .
4 . If required: Repeat steps 1-2 until the chain
is fixed during sharpening .
6 .6 Check and adjust the wire
Note: If the wire is not correctly set, the
grinding machine will not operate correctly .
The manufacturer initially sets the wire, but
it will become worn during normal machine
operations . Always make sure that the wire is
set correctly . If necessary, adjust or replace
the wire .
1 . Press the power button to turn on the
machine .
2 . Set the grinding speed knob to high speed .
See section 3 .6 .1, “Grinding speed knob” .
3 . Press the grinding head positioning button
to turn the grinding head to the left .
4 . Set the top-plate angle to 30° . See section
5 .2 .3, “Set the top-plate angle” .
5 . Set the chain pusher switch to ON .
6 . Place a 0 .05 mm (0 .0019
″
) feeler gauge (B)
between the lifting arm (C) and the flange (A)
and make sure that the lifting arm completely
meets the flange for about 1 .5 seconds before
it lifts again .
IMPORTANT The feeler gauge must sit
tightly between the lifting arm and the flange .
There must be no gap .
• If the test is successful, the wire does not
need to be adjusted . The test is finished .
• If the lifting arm and flange do not completely
meet or do not meet long enough, perform the
next steps .
A
B
C
