+
4/5/6
5
4
C
4/5/6
5
4
C
OFF
ON
3X
11X + 1X (Hold)
+
4/5/6
5
4
C
4/5/6
5
4
C
26
Returning to Factory Default Settings
Turn the ignition switch from the
OFF position to the ON position
three (3) times leaving it in the Off
position the third time.
Step 1
Before 15 seconds has passed, push
and release the valet switch eleven
(11) times then push the valet switch a
twelfth time and hold it down until six
(6) short chirps/beeps and a long chirp
then release it. You are now in the
“Return to Factory Default Setting”
programming mode.
Step 2
Press the ( ) and ( )button on the
transmitter together for 6 seconds,
there will be a confirmation six chirp
with 3 long chirp and 3 parking light
flashes to confirm the system’s Alarm
Features Programming Part 1, 2 and 3
all return to factory default setting.
Step 3
ON
Turn On the Ignition
3 long chirps & 3 flashes of the parking lights will
confirm exit of the programming mode.
Note:
Waiting 15 seconds after the last command will also cause the
system to automatically exit the programming mode.
Step 5
Remote Start Operation and Feature Programming (Continued)
If all things seem correct, press the
( ) button twice to stop the
engine running. If a cranking
problem is noticed, move to Step 6
to adjust the start timer feature
otherwise follow Step 5 and get out
of the programming mode.
Press the ( ) button on the
transmitter to get out of the
programming mode. You will hear
three (3) long chirps and get 3
parking light flashes for
confirmation.
If the engine cranks too long or not
long enough, you may need to adjust
the start timer. Press the
( ) button on the transmitter to
change the start timer length as
shown in the chart. Follow the chart
and listen for the different chirp count
to select the time you want to use.
Bi
6
4/5/6
5
4
C
4/5/6
5
4
C
Press the button first, then within 3
seconds press and hold the and
buttons at the same time on the
transmitter for 6 seconds. There will
be six confirmation chirps with 3 long
chirps to confirm the system “Start
Feature 1 and 2 Programming all
returns to factory default setting.
Step 4
4/5/6
5
4
C
After adjusting the stat timer press the
( ) button twice on the transmitter
to start the engine by remote. Listen
for an over-run or under-run
indication. Re-adjust as needed.
Press the ( ) button on the
transmitter to get out of the
programming mode. You will hear
three (3) long chirps and get 3
parking light flashes for confirmation.
Bi
6
Step 4
Step 5
Step 6
Step 7
Step 8
M11A-IM 3/8/05 3:43 PM Page 26
