23
4/5/6
5
4
C
Remote Start Operation and Feature Programming
Tachometer Detection Programming
If you have previously selected tachometer detection, you are required to program 2 additional features as enclosed.
Feature 1: RPM Learning
Turn the ignition switch from the
OFF position to the ON position
three (3) times leaving it in the Off
position the third time.
OFF
ON
3X
Step 1
Before 15 seconds has passed,
push and release the valet switch
nine (9) times then push the valet
switch a tenth time and hold it down
until five (5) short chirps/beeps +
one (1) long chirp/beep is heard
then release it.
9X + 1X (Hold)
Step 2
Start the vehicle’s engine
with the ignition key (while
the engine is running the
parking lights and the LED
should be flashing. If they
are not you need to re-
check your tachometer
wire connection).
ON
Step 5
START
Press and hold the valet
switch. When the RPM
level is learned, you will
hear a long chirp/beep and
the LED will be on steady
for 2 seconds.
Step 6
Turn OFF the ignition to
stop the engine.
Remember, you are still in
programming mode.
OFF
Step 7
Press the ( ) button twice on the transmitter to start the
vehicle. If everything is correct, the engine will crank and fire
without over-running or under-running the starter. If all things
seem correct, press the (
) twice to stop the engine from
running. If a cranking problem is noticed, move to Step 9 to
adjust the crank detection feature otherwise follow Step 8 and
get out of the programming mode.
Press and release the ( )
button once. The LED will flash once
and you will hear 1 chirp/beep to
indicate that you are in RPM Feature
learning mode.
Press the (Lock) button on the transmitter to get
out of the programming mode. You will hear 3
long chirps and get 3 parking light flashes for
confirmation.
Step 8
Step 9
Step 3
SET
Bi
6
4/5/6
5
4
C
+
Press unlock button before
you turn on the ignition
key.
4/5/6
5
4
C
Step 4
M11A-IM 3/8/05 3:43 PM Page 23
