If all things seem correct, press the
( ) button twice to stop the
engine running. If a cranking
problem is noticed, move to Step 6
to adjust the crank detection feature
otherwise follow Step 5 and get out
of the programming mode.
Step 4
Press the (
) button twice on the
transmitter to start the engine by remote.
Setting the crank detection to Low should
have solved the over-cranking problem.
Note:
Let engine run for 10 seconds
or more to ensure proper operation.
Press the ( ) button twice to stop
the engine
Press the ( ) button on the
transmitter to get out of the
programming mode. You will hear
3 long chirps and get 3 parking
light flashes for confirmation.
If the engine shuts down after 10
seconds you may need to adjust the
crank detection level. Press the
( ) button on the transmitter to
change the crank detection level
from Low to Hi. You will hear 2
chirp/beeps to indicate the feature
has been changed to the Hi
selection.
Step 7
Step 5
Step 6
Step 9
If the engine still cranks too long or
not long enough, you may need to
adjust the start timer. Press the
( ) button on the transmitter to
change the start timer length as
shown in the chart. Follow the chart
and listen for the different chirp
count to select the time you want to
use. Restart the engine by remote
( ) twice to ensure proper operation
Step 8
Bi
6
4/5/6
5
4
C
4/5/6
5
4
C
SET
Bi
6
4/5/6
5
4
C
4/5/6
5
4
C
Feature 2: Start Timer Programming
Press the ( ) button on the
transmitter to get out of the
programming mode. You will hear 3
long chirps and get 3 parking light
flashes for confirmation.
Turn the ignition switch from the
OFF position to the ON position 3
times leaving it in the OFF position
the third time.
OFF
ON
3X
Step 1
Before 15 seconds has passed, push
and release the valet switch 9 times
then push the valet switch a tenth time
and hold it down until 5 short
chirps/beeps + 1 long chirp/beep is
heard then release it.
9X + 1X (Hold)
Step 2
Press the ( ) button twice on the
transmitter to start the vehicle. If
everything is correct, the engine will
crank and fire without over-running
or under-running the starter.
Note:
Let engine run for 10 seconds
or more to ensure proper operation.
Step 3
Bi
6
Fixed Crank Timer Additional Programming
If you have selected Elapsed Timer, you may be required to program 1 additional feature as follows.
Remote Start Operation and Feature Programming
Remote Start Operation and Feature Programming (Continued)
25
M11A-IM 3/8/05 3:43 PM Page 25
