Markem Imaje 9028, User Manual, Page: 93 / 177

Editing a message
A46980-AB.doc
92/176
EAN 128 and code 128
The dialog box is as follows:
□ 47 characters maximum.
□ The set of characters is divided into 4 menus that can be found in
Mode 128
(Code A,
Code B, Code C) and
Characters to:
Code A: comprises all the standard upper case alphanumeric characters, the
command characters and the special characters. This is the default mode.
Code B: comprises all the standard upper case and lower case alphabetic
characters, digital characters and special characters.
Code C: comprises the set of 100 pairs of figures from 00 to 99 and special
characters (characters are entered two at a time).
Characters to: comprises the command characters (NUL, SOH, etc.) and special
characters (FNC1, SHIFT, AI, etc.). The content of the dialog box depends on the
choice of Mode 128. These characters may be variable (counter, date, etc.).
Two AI characters (identifiers), if they include a data field of any length, allowing for
showing it in cleartext in parentheses without the parentheses being coded.
ATTENTION
- The highlighted characters A, B, C appear in the composition
corresponding to codes A, B, C.
- Only mode B is authorized if Optimization is checked in the
barcode parameters.
- The last character entered is always considered as being the
check digit. If the figure is not correct, the printer will signal this
and automatically replace it with the correct value.